Low cost, high accuracy, fully overload-protected

Mini-Mounts allow platform scales to be built in many sizes and capacitiesThe Mini-Mount allows direct mounting of a weigh platform or platter etc. for low profile, high-accuracy platform scales. Four Mini-Mounts are located at the corners of a weigh platform that can be any size and shape. Different capacities allow a single set of components to be used in scale platforms of several sizes and capacities with low production cost in high volume.  Check our other scale components here.

Product Features

The Mini-Mount has overload protection built in and can be used with confidence in platform scales where dropped items and other abuse is present. . . . . Read more
  • Capacity – current range 20 to 50 kg per mount.  Other capacities available by special order.
  • Fully overload protected.
  • Higher accuracy than single point load cell-based scale platforms.
  • Very low-cost in quantity.
  • High stiffness gives very fast response.
  • Just 2” high, allowing low profile platform construction.
  • IP65 protection against liquids.
  • Fully RoHS and CE compliant.
  • 1000 ohm impedance reduces electrical load and self-heating.  Due to this, warm-up drift is negligible.
  • Allows wide range of platform sizes.
  • Different platter mounting methods available to allow you to use secured or drop-on platters.
  • Accurately matched output allows total interchangeability and replacement without calibration.
 

Applications

  • High accuracy, high resolution platform scales.
  • Conveyor scales.
  • Packaging systems.
  • Checkweighers.
  • Small tank and vessel weighing.
  • Shipping systems.
  • High-accuracy personal and animal scales.

Mini-Mount design Copyright © Scale-Tron Inc. 2016

Auto-Cal platform scales give you an edge

Auto Cal is a shunt-calibration system that, when used with suitable Auto Cal load cells, can eliminate test weights after the initial calibration.  Shunt calibration is a method of using a resistance in parallel with one arm of the load cell bridge to simulate a known load.  Once the scale is calibrated, the resistance is switched in and the reading recorded.  As a result, it can be used in subsequent accuracy checks and recalibration.  Furthermore, when load cells are manufactured to tight tolerances they can be interchanged without need for recalibration.  This contributes further to the Auto Cal system.  Other Auto-Cal items are Scale-Bar load cell assemblies and Scale Transmitters.

BROCHURE INFORMATION, PRICING